Battery Back Up Kit - Vermont Castings 33CFDVNV Installation And Operating Instructions Manual

CFDV Series Gas Fireplace
faster and more efficient. Operating your appliance in cold
climate (aka standing) pilot mode will prohibit the need for
multiple ignition attempts and will prevent the system from
delaying start up or locking out.
Figure 1 –
CFDV Fireplace Controls–IPI (featuring Cold Climate option)
BATTERY BACK UP KIT INSTALLATION
The IPIBK battery back-up kit is intended for use with the
Ecologic IPI control system. The use of this battery back-
up kit will allow the fireplace to continue operating in the
event electric power is lost, such as may occur during
severe snow or ice storms.
Kit Contents:
• One (1) Battery holder with wires
• One (1) Installation instruction sheet
Not included:
• Four (4) AA alkaline batteries
WARNING
Turn off, unplug, and allow the fireplace to cool be-
fore installing the battery back-up kit. Only a qual-
ified service person should service and repair the
fireplace. A qualified service person must connect
and disconnect the fireplace to the gas supply. Fol-
low all local codes.
6
Cold Climate Switch
To activate the cold climate option, simply move the cold
climate toggle switch located on the right side of the black
control center to the "On" (left) position. (Figure 1) You can
operate your appliance in this mode regardless of whether
you are using a remote control, wall switch or thermostat.
Master Switch
NOTE: To ensure you will always have back-up pow-
er available to your fireplace, replace batteries before
each heating season. Four (4) AA alkaline batteries are
required, (not included).
Installation Instructions
1. Find the appropriate male and female wire terminals
attached to the unused red and black colored wires
(Figure 2) on the wire harness located in the lower
control area of the fireplace.
2. Connect the female terminal of the red wire to the red
male terminal of the battery backup kit. Push termi-
nals together firmly. (Figure 3)
3. Connect the male terminal of the black wire to the
female black terminal of the battery backup kit. Push
terminals together firmly. (Figure 4)
4. Install four (4) fresh "AA" alkaline batteries into the
battery holder. Note correct polarity of each battery.
(Figure 5).
5. Place battery holder with batteries into the lower con-
trol area behind access panel with supplied Velcro.
6. Installation complete!
PRODUCT FEATURES
20306739