OPTIONAL ACCESSORIES
FORCED AIR KIT
If you are installing the forced air kit (Models BLO24T or
BLOT), see the installation instructions provided with the
kit for electrical wiring requirements or the blower instal-
lation section.
Model VFC24 uses blower model BLO24T.
Model VFC32 uses blower model BLOT.
The fi rebox must be connected to main power supply at
time of fi rebox installation. The blower must be installed
prior to the installation of the unvented heater. The electri-
cal connections must be made before the fi rebox is framed
and enclosed in the fi nished walls.
INSTALLING OPTIONAL FIREBRICK
PANELS
NOTE: Firebrick liner kits may be used only with the VFC
vent free fi replace systems. Please verify the size and
model number of your insert to be certain the kit you pur-
chased is correct.
KIT CONTENTS:
• One (1) Center panel
• Two (2) self-drilling #8 screws
• One (1) Left panel
• Two (2) Brick retainer brackets
• One (1) Right panel
TOOLS REQUIRED:
Drill with 1/4" hex head or Phillips bit
INSTRUCTIONS:
1. Remove screen frame, stones, fi reglass or logs (if ap-
plicable) per the VFC Installation and Operating In-
structions.
2. Place rear ceramic fi rebrick panel against the center of
the rear wall of the fi rebox. Place on rear log support
bracket.
3. Place left and right ceramic fi rebrick panels against
fi rebox sides and attach at the top with retainer bracket
with supplied self drilling screws.
4. Replace fi reglass, stones and/or logs as applicable
and re-install screen frame.
20308011
Retainer
Brackets
Figure 36 -
Install Side Firebrick Panel
Figure 37 -
Install Back Firebrick Panel
VFC Vent Free Fireplace System
33