Installing Brick Liner Kit; Rockwool Placement - Vermont Castings 33CFDVNV Installation And Operating Instructions Manual

FINAL INSTALLATION
Top Flange
Left Panel
Rear Panel
Figure 81 –
Porcelain liner installation

INSTALLING BRICK LINER KIT

Kit contents:
• One (1) Right panel
• One (1) Left panel
• One (1) Rear panel
• Two (2) Self-drilling #8 screws
• Two (2), Retainer brackets
1. Remove the canopy, safety barrier, glass door frame
and log set (if applicable) .
2. Remove the top heat shield.
3. Install the center firebrick panel on the back wall first.
Stand firebrick panel straight up against the back of
fireplace with the bottom edge at bottom of inner firebox.
4. Repeat Step 3 with the left and right side firebrick pan-
els. Secure the top of each side firebrick panel to the
fireplace with one retainer bracket and one screw.
5. Use a screw gun to drive in the self-drilling screw into
the sheet metal through the hole in the retainer bracket.
6. Re-install top heat shield.
7. Re-install log set, glass door, safety barrier and canopy.
20306739
KT1892
Right Panel
KT1892
porcelain panels
Retainer
Bracket
Left Panel
Rear Panel
Figure 82 –
Firebrick liner installation
KT1893
firebrick
ROCK WOOL PLACEMENT
1. Your fireplace is supplied with three (3) 8-gram bags
of rock wool embers: Use one (1) 8 gram bag of rock
wool for propane/LP models and up to three (3) bags
of rock wool for natural gas models depending on the
size of your fireplace.
2. For best results in flame appearance and operation, pull
the rock wool apart into dime-sized pieces or smaller.
Cover the entire ported surface of the burner with one
thin layer of rock wool. Figure 83
3. Place the logs on the burner. Refer to the "Log Place-
ment Section." Light the unit and after 15 minutes check
burner flame and glow. Adjust embers as necessary to
achieve an even and clean flame.
Rock Wool Area
CFDV Series Gas Fireplace
Right Panel
FP3016
36CFDV rockwool placement
KT1893
FP3016
49