Signature Command System Operation; Features; Battery Installation; System Confi Guration/Setup - Vermont Castings ICFDV40LNTSC Installation And Operating Instructions Manual

ICFDV40 Fireplace Insert

FEATURES

Command Center
•
Easy Access Function Operation and System Confi g-
uration
•
Operation Confi rmation/Fault Diagnostic Indications
(LED/Buzzer)
•
ON/OFF/HI/Med/Low Operation
•
Optional Wall Mounting
Control Board
•
Electronic Ignition
•
Pilot Lockout safety feature
•
Electric Power Regeneration from Thermopile to save
battery
•
6-hour Automatic Shut Down Option
•
Convenient NG/LP Gas Type Conversion
•
Standing Pilot/Intermittent pilot Conversion
•
Previous settings Restoration Ability (Memory Off)
•
Uninterrupted Operation During Power Outage (Auto-
matic Battery Backup)
•
ON/OFF RF Remote Receiver
•
Optional Transmitter Learn Capability
AC Module Board (Requires TSFSC Remote)
•
Easy Snap-on Design
•
Embedded Compact 120 VAC Adapter with Auto
Battery Back up Feature
•
Remote Controlled 3-step Blower, Lighting, and On/
Off Auxiliary AC Outputs
Transmitter (Optional)
Three Flame Height Settings
Low battery Indication for Transmitter
Child Proof Lock-out
LCD Backlight
Security Codes 16
Countdown 6 hr Timer
Standard Thermostatic Control Mode
®
Smart Mode Thermostat,
(Auto Flame & Blower Modulation)
Three Brightness Settings for Lights
Three Speed Control for Blower
On/Off Auxiliary
Programmable timer to turn blower on and off

BATTERY INSTALLATION

The Command Center uses four (4) "AA" batteries as
back up for power outages. The system can operate for
approximately six (6) months on battery power.
26
SIGNATURE COMMAND SYSTEM OPERATION INSTRUCTIONS
TSFSC
X
X
X
X
X
X
X
X
X
X
X
X
To Install Batteries (not included):
1. Press down the battery door tabs and pull out to remove
battery door.
2. Install the batteries as indicated on Command Center.
3. Close battery door by snapping in place.
4. When the four (4) batteries are installed the system will
operate without power.
5. The batteries should be replaced when the LED indi-
cates low battery or at least once a year.
RF Receiver
ON/OFF
NG/LP
Conversion
Control
Board
OFF
LED
ON
Master Switch
Command
Center
Figure 36 -
Signature Command System Components
SYSTEM CONFIGURATION/SETUP
All System confi guration/setup is done on the Command
Center.
NOTE: When using On/Off wall switch, the switch must be
in the ON position to perform all confi guration set ups at
the command center.

COLD CLIMATE OPTION

Choose the Mode That Best Suits Your Needs
The Signature Command System is designed to operate
in either Standing Pilot or Intermittent Pilot mode.
•
The Standing Pilot Mode is best for colder climates
when the pilot must remain on continuously to prevent
condensation and ensure reliable operation.
To Thermopile
To Sensor
To Sparker
To Command Center
To Stepper Motor
To Valve
Battery Door
20304852