Insert Installation; Glass Frame Removal; Brick Panel Installation - Vermont Castings VC41LDVINTSC Installation And Operating Instructions Manual

Clean face direct vent fireplace insert
Table of Contents

Advertisement

VC41LDVI/VC41CDVI Gas Fireplace Insert

GLASS FRAMe ReMOVAL

1. Before installation, the glass frame removal tool must
be removed from the side of the unit. As you face the
front of the unit, the glass frame removal tool is located
on the right side.
2. Remove the screw securing the tool to the unit. remove
tool and replace screw.
3. Use the large end of the tool to unlatch the two (2) glass
frame latches.
4. Pull glass frame away from unit and lift up and away.
Glass Frame
Removal Tool
Figure 12 -
Use Tool (provided) to Release Glass
Frame Latches
WARNING
Make sure the glass panel edges do not
touch any metal parts during thermal ex-
pansion.
AVERTISSEMENT
Always use gloves when handling broken
glass.
14
Glass Frame
Latch
HOT GLASS WILL
CAUSE BURNS.
Fp2967
DO NOT TOUCH GLASS
UNTIL COOLED.
glass frame latch tool
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Un panneau vitré chaud peut
causer des brûlures.
Laissez refroidir le panneau
vitré avant d'y toucher.
Ne laisser jamais les enfants
toucher le panneau vitré.

BRICK PANeL INSTALLATION

Figure 13
Kit contents:
1, Rear Panel
1, Left Panel
1, Right Panel
4, Self-tapping Screws
1. Remove brick panels and retainers from packaging.
2. Remove two (2) screws on each side of front edge of
chamber.
3. Install one (1) front brick retainer bracket on each side
with the screws removed in Step 2.
4. Carefully set rear brick panel with notch up on log sup-
port.
5. Carefully place right or left side brick panel in place
making sure front edge of brick is behind the front brick
retainer bracket.
6. Using self-tapping screw, install upper brick retainer
bracket (with two (2) holes and slot with the long side
down into the top of the inner chamber.
7. Using self-tapping screw, install lower brick retainer
bracket (smaller bracket) into the log support bracket
centered on brick panel.
FP2967
8. Repeat Steps 6 & 7 for remaining side.
Remove Screws
Left Brick
Rear Brick Panel
Panel
with Notch Up
Upper Brick
Retainer
Bracket
Lower Brick
Retainer
Bracket
Front Brick
Retainer
Figure 13 -
Install Brick Panels
GLASS FRAMe ReMOVAL
2, Upper Brick Retainer Brackets
2, Lower Brick Retainer Brackets
2, Front Brick Retainer Brackets
Right Brick
Panel
FP2982
install brick panels
FP2982
20304685

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vc41ldviptscVc41cdvintscVc41ldvi

Table of Contents