Enabling The Remote Presence Feature; Obtaining The Ip Address For The Web Interface Access - IBM x3650 M3 Installation And User Manual

Enabling the remote presence feature

Use this information to enable the remote presence feature.
About this task
To enable the remote presence feature, complete the following steps:
Procedure
1. Install the virtual media key into the dedicated slot on the system board (see
2. Turn on the server.

Obtaining the IP address for the Web interface access

To access the Web interface and use the remote presence feature, you need the IP
address for the IMM. You can obtain the IMM IP address through the Setup utility.
About this task
To locate the IP address, complete the following steps:
Procedure
1. Turn on the server.
2. When the prompt <F1> Setup is displayed, press F1. If you have set both a
3. From the Setup utility main menu, select System Settings.
4. On the next screen, select Integrated Management Module.
5. On the next screen, select Network Configuration.
6. Find the IP address and write it down.
7. Exit from the Setup utility.
170
System x3650 M3 Types 4255, 7945, and 7949: Installation and User's Guide
Replacing an IBM virtual media key).
Note: Approximately 3 minutes after the server is connected to ac power, the
power-control button becomes active.
Note: Approximately 3 minutes after the server is connected to ac power, the
power-control button becomes active.
power-on password and an administrator password, you must type the
administrator password to access the full Setup utility menu.