IBM x3650 M3 Installation And User Manual page 124

Figure 110. Microprocessor release lever rotation
110
System x3650 M3 Types 4255, 7945, and 7949: Installation and User's Guide
4. Remove PCI riser-card assembly 2 (see "Removing a PCI riser-card assembly"
on page 46).
5. Remove the microprocessor air baffle (see "Removing the microprocessor 2 air
baffle" on page 48).
6. Locate the second microprocessor socket on the system board.
7. Rotate the heat-sink release lever to the fully open position.
8. Install the microprocessor:
a. Rotate the microprocessor release lever on the socket from its closed and
locked position until it stops in the fully open position.
b. Rotate the hinged microprocessor bracket frame into the open position.
c. Remove the microprocessor socket dust cover from the surface of the
microprocessor socket, if one is present. Store the dust cover in a safe
place.
d. Touch the static-protective package that contains the microprocessor to any
unpainted metal surface on the server. Then, remove the microprocessor
from the package.
Attention:
v Do not touch the microprocessor contacts; handle the microprocessor by
the edges only. Contaminants on the microprocessor contacts, such as oil
from your skin, can cause connection failures between the contacts and
the socket.
v Handle the microprocessor carefully. Dropping the microprocessor
during installation or removal can damage the contacts.
v Do not use excessive force when you press the microprocessor into the
socket.
v Make sure that the microprocessor is oriented and aligned and
positioned in the socket before you try to close the lever.