Removing The Sas Riser-Card And Controller Assembly - IBM x3650 M3 Installation And User Manual

Removing the SAS riser-card and controller assembly

To remove the SAS riser-card and controller assembly from the server, complete the
steps for the applicable server model.
About this task
v 16-drive-capable server model:
Figure 131. SAS riser-card and controller assembly removal
v Tape-enabled server model:
Figure 132. SAS controller assembly removal
1. Press the assembly release latch toward the rear of the server and lift that
end of the SAS controller assembly a little. Place your fingers underneath the
upper portion of the SAS riser-card and lift the assembly from the system
board.
2. Lift the assembly out of the server.
Chapter 2. Installing optional devices
129