Trailering The Boat; Conditions Affecting Operation; Weight Distribution (Passengers And Gear) Inside The Boat; The Bottom Of The Boat - MerCruiser Axius 350 MAG User Manual

Section 3 - On The Water
Use extreme caution when operating in shallow water or where underwater objects are
known to be present. No impact protection is provided in reverse; use extreme care to
prevent striking submerged objects while operating in reverse.
IMPORTANT: Impact protection system cannot be designed to ensure total protection from
impact damage under all conditions.

Trailering the Boat

IMPORTANT: The Axius system can not steer without the engines running. If your vessel
requires a specific steering angle upon trailering, obtain that angle prior to keying down the
engines.
The boat can be trailered with the sterndrive unit in the up(out) or down(in) position. Ensure
adequate clearance between the road and sterndrive when transporting. If you require
additional clearance, place the sterndrive unit in full trailer position and support it with an
optional trailer kit, which is available from your authorized Mercury MerCruiser dealer.

Conditions Affecting Operation

Weight Distribution (Passengers and Gear) Inside the Boat

Shifting weight to rear (stern):
• Generally increases speed and engine RPM
• Causes bow to bounce in choppy water
• Increases danger of following wave splashing into the boat when coming off plane
• At extremes, can cause the boat to porpoise
Shifting weight to front (bow):
• Improves ease of planing
• Improves rough water ride
• At extremes, can cause the boat to veer back and forth (bow steer)

The Bottom of the Boat

To maintain maximum speed, the boat bottom should be:
• Clean, free of barnacles and marine growth
• Free of distortion; nearly flat where it contacts the water
• Straight and smooth, fore and aft
Marine vegetation may accumulate when the boat is docked. This growth must be removed
before operation; it may clog the water inlets and cause the engine to overheat.

Cavitation

Cavitation occurs when water flow cannot follow the contour of a fast‑moving underwater
object such as a gear housing or a propeller. Cavitation increases propeller speed while
reducing boat speed. Cavitation can seriously erode the surface of the gear housing or the
propeller. Common causes of cavitation are:
• Weeds or other debris snagged on the propeller
• Bent propeller blade
• Raised burrs or sharp edges on the propeller

Ventilation

Ventilation is caused by surface air or exhaust gases that are introduced around the
propeller resulting in propeller speed‑up and a reduction in boat speed. Air bubbles strike
the propeller blade and cause erosion of the blade surface. If allowed to continue, eventual
blade failure (breakage) will occur. Excessive ventilation is usually caused by:
Page 42 90-899883234 JANUARY 2008