Changing Filter; Steering Fluid; Checking And Filling Steering Fluid - MerCruiser Axius 350 MAG User Manual

CHANGING FILTER

1. Remove and discard oil filter.
2. Coat sealing ring on new filter with engine oil and install.
3. Tighten oil filter securely (following filter manufacturer's instructions). Do not
overtighten.
4. Remove oil fill cap.
IMPORTANT: Always use dipstick to determine exactly how much oil is required.
5. Add recommended engine oil to bring level up to the bottom of the OK range on the
dipstick.
6. With the boat at rest in the water, check the oil level and add specified fluid to bring the
oil level up to, but not over, the full or OK range.
NOTE: Adding 0.95 liters (1 quart) of engine oil will raise the level from the add mark to the
top of the OK range.
Axius 5.0, 5/7 and Axius SeaCore 5.0,
7. Start the engine, run the engine for three minutes, and check for leaks. Stop the engine.
Allow approximately 5 minutes for the oil to drain into the oil pan.
8. With the boat at rest in the water, check the oil level.

Steering Fluid

Checking and Filling Steering Fluid

IMPORTANT: Use only specified lubricant.
IMPORTANT: Running the pump dry will damage the pump. Always check steering fluid
levels before operating the boat.
1. Stop the engine.
2. Center the sterndrive unit.
3. Using a clean, lint‑free cloth, wipe the dirt and debris from the fill cap and the exterior
of the fluid reservoir.
4. Remove the fill cap from the reservoir and observe the fluid level using the dipstick.
90-899883234 JANUARY 2008
a - Oil filter
Engine Model
5.7
a
Engine Oil Capacity
4.25 liters (4.5 U.S. qt.)
Section 5 - Maintenance
6068
Fluid type
Mercury/Quicksilver Synthetic Blend
MerCruiser Engine Oil 25W‑40
Page 77