Multi-Point Drain (Mpd) System - MerCruiser Axius 350 MAG User Manual

Section 6 - Storage
2. Remove three blue drain plugs: one from the distribution housing (lower front, port side)
and two from the seawater pickup pump (front, starboard side).
3. Verify that water is draining from each opening.
4. Allow the system to drain for a minimum of five minutes. We recommend leaving the
drain system open while transporting the boat or performing other maintenance to
ensure that all water is drained.
5. Crank the engine over slightly with starter motor to purge any water trapped in the
seawater pickup pump. Do not allow the engine to start.
6. Before launching the boat or starting the engine, close the drain system by installing
the three blue drain plugs.
Multi‑Point Drain (MPD) System
1. Place the boat on a level surface to ensure complete draining of the system.
2. Remove the blue drain plugs from the following locations. It may be necessary to clean
out the drain holes using a stiff piece of wire. Do no until the entire system is drained.
a.
b.
Page 126
a
a - Blue drain plug
Port and starboard side of cylinder block
Bottom of exhaust manifolds
b
a
a - Cylinder block drain plug
a
b
a
b - Exhaust manifold drain plug
90-899883234 JANUARY 2008
6142
6129