Output Terminal And Receptacle - MULTIQUIP TLG8SSK4F Operation And Parts Manual

OUTPUT TERMINAL
The output terminal shown in Figure 7 is located on the
side (below the control panel) of the generator. Lift up on
the cover to gain access to terminal lugs.
NOTICE
Terminal lugs "O" and "Ground" are considered bonded
grounds.
ø ø
1 and 3
240 -120 VAC
OUTPUT TERMINALS
V
U
BLACK RED
Figure 7. Output Terminal
120 VAC GFCI Receptacle
There is a 120 VAC, 20 amp GFCI (Duplex Nema 5-20R)
receptacle below the control panel. The receptacle is
protected by a 20 amp circuit breaker. This breaker is
located on the control panel. The load output (current) of
the GFCI receptacle is dependent on the load requirements
of the U, V, and W output terminal lugs.
Pressing the reset button resets the GFCI receptacle
after being tripped. Pressing the test button (Figure 8) in
the center of the receptacle will check the GFCI function.
Receptacle should be tested at least once a month.
Figure 8. GFCI Receptacle
PAGE 22 — TLG8SSK4F PORTABLE GENERATOR• OPERATION AND PARTS MANUAL — REV. #0 06/21/16)

OUTPUT TERMINAL AND RECEPTACLE

NEUTRAL GROUND
TERMINAL
TERMINAL
W
O
BLUE WHITE GREEN
Turn the voltage regulator control knob (Figure 9) on
the control panel to obtain the desired voltage. Turning the
knob clockwise will increase the voltage, turning the knob
counterclockwise will decrease the voltage.
Figure 9. Voltage Regulator Control Knob
Connecting Loads
Loads can be connected to the generator by various
methods; output terminal lugs, camlocks, or the convenience
receptacles. Make sure to read the operation manual before
attempting to connect a load to the generator.
To protect the output terminals from overload, a 3-pole,
18A main circuit breaker is provided. Make sure to switch
all circuit breakers to the OFF position prior to starting the
engine.
HARD WIRE
HOOKUP PANEL
U
V O
W
GROUND
LOAD
NEUTRAL
Figure 10. Connecting Loads
GFCI
RECEPTACLE
LOAD