Components (Engine) - MULTIQUIP TLG8SSK4F Operation And Parts Manual

Portable generator

Table of Contents

INITIAL SERVICING

The engine (Figure 6) must be checked for proper

lubrication and filled with fuel prior to operation. Refer to the

manufacturer's engine manual for instructions and details

of operation and servicing.

1. Water Drain Cock — Open this cock to drain water.

2. Fuel Filter — Prevents dirt and other debris from

entering the fuel system. Replace filter as recommended

in the maintenance section of this manual.

3. Fuel Feed Pump — Pumps fuel to the injection system.

4. Oil Dip Stick/Gauge — Remove to check amount

and condition of oil in crankcase. Refill or replace with

recommended type oil as listed in Table 8.

5. Speed Control Lever — Controls engine speed. This

lever is factory set at 3600 rpm to maintain proper

voltage and frequency. DO NOT adjust this lever out

of factory range.

6. Injector Pump — Provides fuel under pressure to the

injector nozzles.

7. Air Filter — Prevents dirt and other debris from

entering the air intake system. Loosen clips on side

of air filter canister to gain access to filter element.

Replace with manufacturer's recommended type air

cleaner only.

TLG8SSK4F PORTABLE GENERATOR• OPERATION AND PARTS MANUAL — REV. #0 (06/21/16) — PAGE 21

Figure 6. Kubota Z482 Series

8. Cooling Fan Blades — Make sure cooling fan blades

9. Fan V-Belt — ALWAYS make sure V-belt is properly

10. Crankcase — Remove to drain crankcase oil. Fill with

11. Starter — Starts engine when ignition key is rotated

12. Oil Filter — Spin-on type, filters oil contaminants.

13. Oil Pressure Switch — Monitors engine oil pressure.

14. Alternator — Provides power to the +12VDC

15. Oil Filler Cap — Fill with recommended type oil as