Special Setup For The Copying; Resolution Setup; Zoom Setup; Assembled Copy Setup - Oki B2500 Series User Manual

B2520 / B2540
9 Adjust the contrast level with the buttons
then confirm with the OK button.
10 Adjust the desired brightness level with the buttons
or , then confirm with the OK button.
11 Choose the paper type NORMAL, THICK with the
buttons or , then confirm with the OK button.

Special setup for the copying

Setups done through this menu become the device
default setups after you confirm.
When the quality of the printing is not
satisfying, you can proceed to a calibration
(see Calibrate your scanner, page 29).

Resolution setup

The RESOLUTION parameter allows you to setup the
photocopy resolution.
841 - ADVANCED FCT/COPY/RESOLUTION
1 Choose the resolution with the buttons
according to the following table:.
Parameter
Low resolution.
DRAFT
Standard resolution for documents
AUTO
containing text and graphics.
Optimal resolution for documents
QUALITY
containing text.
TEXT
Optimal resolution for documents
PHOTO
containing photographies.
2 Confirm your choice by pressing the OK button.
You can also change the resolution by
pressing the

Zoom setup

The ZOOM parameter allows you to reduce or enlarge an
area of a document by choosing the origin and the zoom
level to apply to the document, from 25 to 400 %.
842 - ADVANCED FCT/COPY/ZOOMING
1 Enter the desired
Alpanumerical keyboard
predefined values with the buttons
2 Confirm your choice by pressing the OK button.
or
or
Signification
button.
zoom level with the
or choose among
and .

Assembled copy setup

,
843 - ADVANCED FCT/COPY/ASSEMBLED
The ASSEMBLED parameter allows you to assemble or
disassemble your copies. Enter the desired setting and
confirm your choice by pressing the OK button.

Analysis origin setup

If you want, you can change the origin of the scanner.
By entering new values for X and Y in mm (X < 209 and
Y < 280), you move the analysed area as shown on the
diagram below.
x
y
844 - ADVANCED FCT/COPY/ORIGIN
1 Select the X and Y coordinates with the buttons
or .
2 Setup the desired coordinates with the digital
keyboard or the buttons
choice by pressing on the OK button.

Contrast setup

The CONTRAST parameter allows to choose the
photocopy contrast.
845 - ADVANCED FCT/COPY/CONTRAST
1 Setup the desired level of contrast with the buttons
and , confirm by pressing the OK button.
2 You can also directly setup the desired contrast
with the button, press several times on this
button until the desired setup without using the
Menu 845.
3 Quit this menu by pressing the

Brightness setup

The BRIGHTNESS parameter allows to lighten or darken
your original document.
846 - ADVANCED FCT/COPY/LUMINOSITY
1 Setup the desired brightness with the buttons
and .
2 Confirm your choice by pressing the OK button.
3 Quit this menu by pressing the
- 14 -
Analysed area
and , confirm your
button.
button.