Panasonic KX-TDA30 Features Manual page 264

1.25 Administrative Information Features
• If the PBX is reset during a conversation, the call will not be recorded on SMDR.
• The following calls are regarded as two separate calls for SMDR:
– Calls before and after the flash/recall/EFA signal is manually sent during a conversation
– Trunk-to-trunk calls by Call Transfer, FWD or DISA (recording each as "incoming call" and
"outgoing call")
• The PBX waits for a preprogrammed time period between the end of dialling and start of the SMDR
timer for outgoing trunk calls. When the PBX has sent out all dialled digits to the telephone company
and this timer expires, the PBX starts counting the call. A display PT shows the elapsed time of the call.
The starting time and the total duration of the call are recorded on SMDR.
→ [208] Call Duration Count Starting Time for LCOT
If the reverse signal detection has been set (→ 1.5.4.5 Reverse Circuit), the PBX will start counting the
call after detecting the reverse signal from the telephone company regardless of the above timer.
• Serial Interface (RS-232C) Parameters
The following communication parameters can be assigned for the Serial Interface (RS-232C) port.
a)
New Line Code: Select the code for the PC or printer. If the PC or printer automatically feeds lines
with carriage return, select "CR." If not, select "CR+LF."
→ [800] RS-232C Parameter—New Line Code
b)
Baud Rate: A baud rate code indicates the data transmission speed from the PBX to the PC or
printer.
→ [800] RS-232C Parameter—Baud Rate
c)
Word Length: A word length code indicates how many bits compose a character.
→ [800] RS-232C Parameter—Word Length
d)
Parity Bit: A parity code indicates what type of parity is used to detect an error in the string of bits
composing a character. Make an appropriate selection depending on the requirements of the PC
or printer.
→ [800] RS-232C Parameter—Parity Bit
e)
Stop Bit Length: A stop bit code indicates the end of a bit string which composes a character.
Select an appropriate value depending on the requirements of the PC or printer.
→ [800] RS-232C Parameter—Stop Bit Length
• Host PBX Access Code
The dialled number including the Host PBX Access code will be recorded on SMDR only if the modified
number setting is selected in the ARS setting for SMDR.
• When a Host PBX Access code is assigned to a trunk group, calls to extensions of the host PBX are
not recorded on SMDR.
• A Host PBX Access Code can be used to record only long distance calls on SMDR when a trunk port
is connected directly to the telephone company (not a host PBX). This is allowed when the long
distance code (e.g., "0") is assigned as the Host PBX Access code. All local calls (e.g., calls that do not
require a "0" to be dialled first) are treated as extensions of the telephone company and do not get
recorded on SMDR, because in this case this PBX recognises the telephone company as the host PBX.
Therefore, only long distance calls are recorded on SMDR.
Installation Manual References
KX-TDA30
2.10.1 Connection of Peripherals
KX-TDA100/KX-TDA200
2.11.1 Connection of Peripherals
KX-TDA600
2.3.2 EMEC Card (KX-TDA6105)
264 Feature Guide