Repositioning The Camber Tube Clamp Socket Screws - Invacare Crossfire T6, Crossfire Titanium, Crossfire All Terrain User Manual

®
Top End Crossfire™
4.12 Repositioning the Camber Tube Clamp
Socket Screws
1. Remove the rear wheels. Refer to 5.7 Removing/Installing Rear
Wheels, page 65.
2. Refer to Socket Screw Mounting Positions in 4.10 Adjusting
Wheelbase Length, Adjusting Center of Gravity (COG), page 45
to determine which socket screw(s) A MUST be moved and
to which mounting positions.
Remove the four socket screws A and washers B from both
3.
camber tube clamps C.
4. Align the desired mounting positions of the camber tube clamps
C with the opening of the camber tube supports D.
48
CAUTION!
– Ensure one empty mounting position remains
between the two socket screws A, otherwise
damage to the wheelchair may occur.
Install the four socket screws A and washers B into the desired
5.
mounting positions of both camber tube clamps C. Hand tighten.
Ensure that both camber tube clamps C are adjust to
the same position in the camber tube support D. This
will ensure that the camber tube E remains at 90° to
each side frame.
Slide the camber tube E forward or backward to adjust the
6.
wheelbase length to the desired position. Securely tighten the
four socket screws A.
7. Install the rear wheels. Refer to 5.7 Removing/Installing Rear
Wheels, page 65.
1134872-D~08