Replacing Screw-On Seat Upholstery Option - Invacare Crossfire T6, Crossfire Titanium, Crossfire All Terrain User Manual

®
Top End Crossfire™

5.6 Replacing Screw-On Seat Upholstery Option

WARNING!
– ALWAYS perform these procedures in the presence
of an assistant. The position of the footrest, camber
tube, seat angle, back angle, the tautness of the back
upholstery as well as the user's condition are directly
related to the wheelchairs stability. Any change to
one or any combination of the five may cause the
wheelchair to decrease in stability. Use EXTREME
caution when using a new seating position. The
addition of anti-tippers may be required.
– After ANY adjustments, repair or service and BEFORE
use, make sure all attaching hardware is tightened
securely - otherwise injury or damage may occur.
WHEELCHAIR DEPTH
14 to 15 inches
16 to 17 inches
18 inches
19 to 20 inches
1. Remove the seat cushion from the wheelchair.
2. Remove the mounting screws that secure the seat upholstery A
to the seat frame.
3. Lift up on the back upholstery cover separating the fastening
strips of the back upholstery cover B from the fastening strips
of the seat (Detail "A").
Remove the existing seat upholstery A.
4.
64
NUMBER OF SCREWS
10
12
14
16
5. Install new seat upholstery A and secure in place with mounting
screws. Tighten securely.
6. Install the seat cushion onto the wheelchair.
DETAIL "A"
1134872-D~08