NETGEAR WAC730 Reference Manual page 17

ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730
To configure basic system settings:

1. Select Configuration > System > Basic > General.
2. Configure the settings as explained in the following table:
Setting
Access Point Name
Country / Region
3. Click the Apply button.
Your settings are saved.
To configure time settings:

1. Select Configuration > System > Basic > Time.
Description
This unique name is the wireless access point NetBIOS name. The name is printed
on the rear label of the wireless access point. The default is netgearxxxxxx, in which
xxxxxx represents the last 6 digits of the wireless access point MAC address. You
can replace the default name with a unique name up to 15 characters long. The
access point name can be retrieved through SNMP.
From the Country / Region menu, select the country where the wireless access
point is installed.
Note: It might not be legal to operate this wireless access point in a region other than
one of those identified in this field.
Initial Setup
17