ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730
Factory Default Settings
You can use the Reset button located on the rear of the wireless access point to reset all
settings to their factory defaults. This is called a hard reset.
To perform a hard reset, use a sharp object to press and hold the Reset button for
approximately 5 seconds (until the Test LED blinks rapidly). This returns the wireless access
point to the factory configuration settings that are shown in the following table.
Note:
Pressing the Reset button for a shorter period of time simply causes
the wireless access point to reboot.
Table 3. Default configuration settings
Feature
Login for management and configuration
LAN IPv4 management address
Subnet mask for IPv4 management address
LAN IPv6 management address
User name (case-sensitive) for login
Login password (case-sensitive) for login
LAN and management features
DHCPv4 client
DHCPv6 client
Untagged VLAN
Management VLAN
SNMP
Syslog
Spanning Tree Protocol (STP)
Link Layer Discovery Protocol (LLDP)
Secure Shell (SSH)
Telnet
Description
192.168.0.100
255.255.255.0
2001::21c:c0ff:fe69
admin
password
Enabled
Disabled
Enabled, VLAN ID 1
VLAN ID 1
Enabled
Disabled
Disabled
Enabled
Enabled
Disabled
Supplemental Information
110