ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730
Setting
11bg modes only
Output Power
6.
Click Apply button.
Your settings are saved.
Note:
For information about how to configure advanced wireless settings,
see
Configure Advanced Wireless Settings
Configure 802.11a/a-na-ac Wireless Settings
To configure the 802.11a/a-na-ac wireless settings:
1.
Select Configuration > Wireless > Basic > Wireless Settings.
Descriptions
Data Rate
From the menu, select the transmit data rate of the wireless
network. The default setting is Best. For a list of all options
that you can select from in 11bg mode, see
Settings
From the menu, select the transmission power of the wireless access point: Full,
Half, Quarter, Eighth, Minimum. The default is Full.
Note:
Increasing the power improves performance, but if two or more wireless
access points are operating in the same area and on the same channel,
interference can occur.
Note:
Make sure that you comply with the regulatory requirements for total radio
frequency (RF) output power in your country.
Initial Setup
22
on page 110.
on page 76.
Factory Default