General Information; Pellet Specifications - Napoleon NPS45 Installation And Operating Instructions Manual

10
Thank you for purchasing a Wolf Steel Ltd. Pellet Appliance. This appliance is designed for use with Pelletized
Wood Only.
EN Please read this entire manual before installation and use of this pellet fuel-burning room appliance. Failure to
follow these instructions could result in property damage, bodily injury or even death.
Keep this manual handy for future reference.
This Pellet Appliance, when installed, must be electrically grounded in accordance with the local codes, or in
the absence of local codes, use the current CSA C22.1 Canadian Electrical Code in Canada or the ANSI/NFPA
70 National Electrical Code in the United States.
This appliance will not operate using natural draft or without a power source for the blower systems and fuel
feed system.
These appliances are equipped with levelling screws that penetrate the front corners of the fi rebox. If these
screws are missing it will have a negative infl uence on the performance of this appliance. Ensure that the
levelling screws are tightened into position.
The protective wrap on plated parts is best removed when the assembly is at room temperature but this can be
improved if the assembly is warmed, using a hair dryer or similar heat source.
If the appliance is installed directly on carpeting, vinyl tile or other combustible material other than wood
fl ooring, the appliance shall be installed on a metal or wood panel extending the full width and depth.
2.4

GENERAL INFORMATION

2.4.1 PELLET SPECIFICATIONS

IT IS IMPORTANT TO SELECT AND USE ONLY PELLETS THAT ARE DRY AND FREE OF DIRT
OR ANY IMPURITIES SUCH AS HIGH SALT CONTENT. DIRTY FUEL WILL ADVERSELY AFFECT
THE OPERATION AND PERFORMANCE OF THE APPLIANCE AND WILL VOID THE WARRANTY.
THE PELLET FUEL INSTITUTE (P.F.I.) HAS ESTABLISHED STANDARDS FOR WOOD PELLET
MANUFACTURERS. WE RECOMMEND THE USE OF PELLETS THAT MEET OR EXCEED THESE
Pellet quality is important, please read the following:
Your Wolf Steel Ltd. Pellet Appliance has been designed to burn premium hard or soft wood pellets only. Do
not use any other type of fuel such as fi re logs or fi re starting pellets, as this will void the warranties stated in
this manual.
The performance and heat output of the pellet appliance is directly related to the quality and moisture of the
pellets. Store pellets in a cool dry area to prevent moisture absorption.
P.F.I. PELLET STANDARDS:
Inorganic Fines (fi ne
particles)
Bulk Density
Size
Ash Content
Moisture Content
Chlorides
Trace Metals
Heat Content
Construction Waste
W415-1472 / 04.21.15
STANDARDS. ASK YOUR DEALER FOR A RECOMMENDED PELLET TYPE.
1% maximum through a 1/8" (3.2mm) screen
38 pound per cubic foot minimum
1/4" (6.4mm) to 5/16" (8mm) diameter, 1/2" - 1 1/2" (13mm
- 38mm) long maximum
No more than 2%
8% maximum
300 parts per million by weight
Less than 100mg/kg
Approximately 8200 BTU per pound minimum
Not to contain any waste materials
WARNING
!
4.5B
64.1
If the fuel does not comply to
this standard the appliance
may not operate as designed.
We recommend the use of
premium grade (1% ash
content) for longer appliance
life and less frequent cleaning.