Optional Blower Installation - Napoleon B46NTR Installation And Operating Instructions Manual

6.7

OPTiONAL BLOwER iNSTALLATiON

ENSuRE THE uNIT IS CoMpLETELY CooL BEFoRE STARTING INSTALLATIoN
To AvoID DANGER oF SuFFoCATIoN KEEp THE pACKAGING BAG AwAY FRoM BABIES AND
CHILDREN. Do NoT uSE IN CRIBS, BED, CARRIAGES oR pLAY pENS. THIS BAG IS NoT A ToY.
A. Remove the safety screen by lifting it up and off of the appliance.
B. Remove the door from the appliance by releasing the four latches.
C. It may be necessary to move the control module aside during blower installation. (Electronic Only)
D.
Attach the two 1/4" connectors (black and white) from the wire harness to the thermodisc.
E. Attach the two 1/4" connectors (black and red) from the wire harness to the blower.
F. Install the clear bumpers supplied onto the bottom of the blower to avoid the blower rubbing against the fl oor of
the appliance.
G. Pivot the blower into the bottom of the appliance, ensuring the gasket remains in place between the blower and
outer shell while sliding the blower against the left side of outer shell into the blower mounting tab. Secure in place
using one screw, see Figures 4 & 5.
NoTE: wITH THE ZIp TIE SuppLIED, ENSuRE ALL wIRES REMAIN CLEAR oF THE BLowER.
FIGURE 4
SCREW
LOCATION
H. Place the control module back into it's original position. Ensure the transformer is plugged into the rear outlet of
the electrical box, refer to Figure 2.
I. The variable speed switch (VSS) will need to be disassembled to secure to the VSS bracket for installation. Place
the VSS through the mounting bracket using the l ock washer to secure it in place. Take the variable speed switch
knob and install into position. (Refer to Figure 6.)
J. To install the variable speed switch the mounting bracket will fi rst need to be installed, remove the two screws
securing the piezo ignitor switch bracket in place, install the VSS mounting bracket into position then reinstall
the two previously removed screws, refer to Figure 6.
FIGURE 6
VSS
BRACKET
K.
Plug the connector from the variable speed switch to the matching connection on the wire harness.
L. For installation of the thermal disc bracket fi rst bend the tab on the bottom of the fi rebox 90 degrees, this will be
the mounting tab for the thermal disc bracket, see Figure 7.
M. Bend the thermal disc bracket 90 degrees and secure it to the fi rebox mounting tab using the two screws supplied,
refer to Figure 7. Ensure that the thermal disc is in contact with the fi rebox base and that the wire harness is
properly attached.
N. Plug the power cord from the blower into the electrical box, refer to Figure 2.
NoTE: The blower is thermally activated, so when it is turned on, it will automatically start approximately
15 minutes after lighting the appliance and will run for approximately 30 minutes after the appliance has been
turned off
!
KNoT BEFoRE THRowING AwAY.
BLOWER
MOUNTING TAB
LOCATION
PIEZO IGNITOR
BRACKET
WARNING
FIGURE 5
BLOWER
FIGURE 7
THERMAL DISC
THERMAL DISC
MOUNTING TAB BRACKET
51
EN
FIREBOX BASE
W415-1613 / B / 06.13.16