Optional Blower Installation - Napoleon Vittoria GD19P-2 Installation And Operation Manual

8.0 optional blower installation

operation
EN
WARNING
!
• Risk of fire and electrical shock!
• Turn off the gas and electrical power before servicing this appliance.
• Use only Wolf Steel approved optional accessories and replacement parts with this appliance. Using
non-listed accessories (blowers, doors, louvres, trims, gas components, venting components, etc.) could
result in a safety hazard and will void the warranty and certification.
• Ensure that the fan's power cord is not in contact with any surface of the appliance to prevent electrical
shock or fire damage. Do not run the power cord beneath the appliance.
• The wire harness provided in the blower kit is a universal harness. When installed, ensure that any excess
wire is contained, prevent it from making contact with moving or hot objects.
ELECTRICAL INSTALLATION TO BE DONE BY A QUALIFIED INSTALLER and must be connected and
grounded in accordance with local codes. In the absence of local codes, use the current CSA C22.1 Canadian
Electrical Code in Canada or the current ANSI/NFPA 70 National Electrical Code in the United States.
If an optional blower is to be used, the blower must be connected to the main power supply. Route a grounded 14
gauge 2-wire power cable to the junction box and ground. At the point where the cable enters the junction box, a
conduit connector must be provided.
Remove the two screws that secure the control panel to the front of the appliance.
A.
Connect the black and red wires of the wire harness to the prongs on the blower.
B.
Connect the white and black wires of the wire harness to the prongs on the
C.
thermodisc.
Place the thermal switch assembly onto
D.
the stud located at the lower left of the
firebox and behind the support bracket.
Connect the wiring for the variable speed
E.
switch.
Insert the blower assembly into the left
F.
side under the firebox, slide into
the clip and place onto the same
stud used for the thermal switch
assembly. Secure with the lock
washer and wing nut supplied.
Ensure that the blower does not
touch the base of the firebox, any
wiring or controls. Ensure that the
thermal switch is touching the wall
of the firebox.
hint:
Rest the thermal disk assembly forward
against the firebox.
Plug into the receptacle on the
G.
right side of the appliance.
Place the variable speed switch
H.
into position and secure with the
pal nut supplied. Reinstall the
control panel and install the variable
speed switch knob.
38
W415-2355 / A / 12.09.20
SPECIFIC BLOWER INSTALLATION
INSTRUCTIONS MUST BE ADDED HERE.
THIS TEMPLATE MUST BE USED WITH ANY
APPLIANCE THAT OFFERS THE BLOWER AS
AN OPTION OR COMES STANDARD WITH THE
APPLIANCE... AS PER THE STANDARD.
INTERRUPTEUR À VITESSE VARIABLE
Control Panel
Variable Speed
Switch Location
GS66 WIRING DIAGRAM
VARIABLE SPEED SWITCH
VARIABLE
SPEED SWITCH
KNOB
RED
BLOWER
SCHÉMA DE CÂBLAGE DU GS66
THERMAL
DISK
ASSEMBLY
BOUTON DE CONTRÔLE
DE VITESSE VARIABLE
BLOWER
ASSEMBLY
ROUGE
35.1
THERMAL SWITCH
WHITE
BLACK
WHITE
WIRE
HARNESS
(included in GS66 kit)
TO POWER SUPPLY
SUPPORT
BRACKET
INTERRUPTEUR THERMIQUE
BLANC
CLIP
NOIR
BLANC
HARNAIS
DE FILS
(inclus avec l'ensemble GS66)