Glowing Embers; Logo Placement - Napoleon B46NTR Installation And Operating Instructions Manual

D
E. Place the right crossover log (W135-0547)
onto the pin located in the right side of the
rear log. Allow it to rest in the notch of the
right log.
6.4

gLOWINg EMBERS

Tear the embers into pieces and place along the front row of ports covering all of the burner area in front of
the small logs. Care should be taken to shred the embers into thin, small irregular pieces as only the exposed
edges of the fibre hairs will glow. The ember material will only glow when exposed to direct flame;
however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. phazer
logs glow when exposed to direct flame. Use only certified "glowing embers" and phazer
from your authorized dealer / distributor.
6.5

LOGO PLACEMENT

Remove the backing of the logo supplied and place on the glass viewing
door, as indicated.
E
A
C
B
Reinstall the door and safety screen, refer
F.
to your installation manual for installation
instructions.
97.1A
49
TM
logs available
TM
½"
(12.7mm)
LOGO
½"
(12.7mm)
W415-1613 / B / 06.13.16
EN