Table of Contents
Advertisement
IMPORTANT:
SAVE THESE INSTRUCTIONS
The Regency I43-1 Gas Fireplace must be installed in
accordance with these instructions. Carefully read all the
instructions in this manual fi rst. Consult the "authority
having jurisdiction" to determine the need for a permit
prior to starting the installation.
Note:
Failure to follow these instructions could cause
a malfunction of the heater which could result in death,
serious bodily injury, and/or property damage. Failure to
follow these instructions may also void your fi re insurance
and/or warranty.
FOR YOUR SAFETY
This appliance requires air for proper combustion. Always
provide adequate combustion and ventilation air. Follow
instructions and information in the current AS5601-2004
or local codes.
GAS PIPE TESTING
The appliance must be isolated from the gas supply pip-
ing system by closing its individual manual shutoff valve
during any pressure testing of the gas supply piping
system at test pressures equal to or less than
1/2 psig. (3.45 kPa).
SPECIFICATIONS
Fuel:
NG or LPG
Electrical:
240 volt. system
Fan:
2 speed, 75/125 CFM
Log Sets:
Ceramic fi bre, 3 per set
Regency I43-1 ULTIMATE Gas Inbuilt Fireplace
INSTALLATION REQUIREMENTS
BEFORE YOU START
Installation is to be carried out ONLY by an authorised
person.
1) The appliance shall be installed in accordance with
the manufacturer's installation instructions,local gas
fi tting regulations, municipal building codes, water
supply regulations, electrical wiring regulations,
with AS5601-2004 (AGA gas installation code) NZS
5261(New Zealand)
2) Installation and repair should be done ONLY by
an authorised person.
3) The appliance should be inspected before use and
at least annually by an authorised service person.
More frequent cleaning may be required due to ex-
cessive lint from carpeting, bedding material, etc. It
is imperative that control compartments, burners and
circulating air passageways of the appliance by kept
clean and free from excessive lint from carpeting.
4) See general construction and assembly instruc-
tions. This appliance may only be installed in a
fl ued noncombustible fi replace. The appliance and
fl ue should be enclosed when installed or passing
through a living area, where children may come in
contact with it.
5) Always connect this fi replace to a fl ue to the outside
of the building envelope. Never fl ue to another room.
Make sure that the fl ue is properly sized and is of
adequate height to provide the proper draft.
6) Inspect the fl ue system annually for blockage and
any signs of deterioration.
7) Any safety glass removed for servicing must be
replaced prior to operating the appliance.
8) To prevent injury, do not allow anyone who is unfa-
miliar with the operation to use the fi replace.
9)
Installer must mechanically attach the supplied label to
the inside of the fi rebox of the fi replace into which the gas
fi replace insert is installed.
"WARNING: This fi replace has been converted for use with a
gas fi replace insert only and cannot be used for burning wood
or solid fuels unless all original parts have been replaced, and
the fi replace re-approved by the authority having jurisdiction.".
5
Advertisement
Table of Contents
