Table of Contents
Advertisement
BRICK PANEL INSTALLATION
1)
Unwrap the brick pattern panels from the protective wrap-
ping.
2)
Open the door and position the side brick panels into place
from the front of the fi rebox. There are two tabs to the
panels in place, on on each side. Carefully bend the tabs
down with a screwdriver until panels are held securely in
place.
Note: Use caution when putting the side panels in as they
can easily be scratched by the hard component
parts.
LOG INSTALLATION
WARNING: Dangerous operating conditions may occur
if these logs are not positioned in their approved loca-
tions. Read the instructions below carefully and refer to
the diagrams. If logs are broken do not use the unit until
they are replaced. Broken logs can interfere with the pilot
and burner operation.
The gas log kit contains the following:
a)
Front Right Log - Part # 902-192
b)
Front Left Log - Part # 902-193
c)
Rear log - Part # 902-194
d)
Embers - Part # 902-151 (1 bag)
(Part # 650-933 for the set of three logs)
1)
Remove the logs from the box and carefully unwrap them.
The logs are fragile, handle with care - DO NOT FORCE
into position.
2)
Place the rear log, carefully sliding it down onto the pins,
with the fl at side of the log facing the back of the unit. See
diagram 1.
3)
Place the left front log, carefully sliding it down onto the
left pins of the front burner. See diagram 2.
4)
Place the right front log, carefully sliding it down onto the
right pins of the front burner. See diagram 3.
5)
Distribute the embers along the front burner but do not
cover the burner ports and around the logs. See diagram
4.
Regency I43-1 ULTIMATE Gas Inbuilt Fireplace
Note: Do not force
logs down.
INSTALLATION
Diagram 1
Diagram 2
Diagram 3
Diagram 4
13
Advertisement
Table of Contents
