Table of Contents
Advertisement
I1200S
Wood Insert
Owners & Installation Manual
www.regency-fi re.com
Tested by:
Installer: Please complete the details on the back cover
and leave this manual with the homeowner.
Homeowner: Please keep these instructions for future reference.
FPI FIREPLACE PRODUCTS INTERNATIONAL LTD. 6988 Venture St., Delta, BC Canada, V4G 1H4
918-665a
04/07/11
Advertisement
Table of Contents
Related Manuals for Regency I1200
Summary of Contents for Regency I1200
- Page 1 I1200S Wood Insert Owners & Installation Manual www.regency-fi re.com Tested by: Installer: Please complete the details on the back cover and leave this manual with the homeowner. Homeowner: Please keep these instructions for future reference. FPI FIREPLACE PRODUCTS INTERNATIONAL LTD. 6988 Venture St., Delta, BC Canada, V4G 1H4...
- Page 2 The pride of workmanship that goes into each of our products will give you years of trouble-free enjoyment. Should you have any questions about your product that are not covered in this manual, please contact the REGENCY DEALER in your area. Keep those REGENCY FIRES burning.
-
Page 3: Table Of Contents
Faceplate, Trim & Optional Fan Support Installation ... 11 Firebrick ...............22 Fan / Blower ..............15 Firebrick Assembly ............16 Draft Control ..............16 WARRANTY Door Handle ..............16 Brick Flue Baffl e & Secondary Air Tube Installation ..16 Warranty ..............23 Screen Door ..............17 http://oee.nrcan.gc.ca/residential/personal/retrofi t-homes/retrofi t-qualify-grant.cfm I1200 Regency Wood Insert... -
Page 4: Safety Label
I1200S Wood Insert. We have printed a copy of the contents here for your review. NOTE: Regency units are constantly being improved. Check the label on the unit and if there is a difference, the label on the unit is the correct one. -
Page 5: With Standard Flue Adaptor
DIMENSIONS WITH STANDARD FLUE ADAPTOR 6" (152mm) Diameter STANDARD FLUE ADAPTOR (171-932) I1200 Regency Wood Insert... -
Page 6: With Offset Flue Adaptor
DIMENSIONS WITH OFFSET FLUE ADAPTOR 21-1/4” (540mm) 6" (152mm) Diameter OFFSET FLUE ADAPTOR (171-936) 14-3/16” (360mm) 12-3/4” (324mm) 22-3/4” (578mm) 21-3/8” (543mm) 17-3/4” (451mm) 22-3/4” (578mm) I1200 Regency Wood Insert... -
Page 7: Installation
fi replace insert. Install and use means. only in accordance with manufacturer’s Regency Inserts are designed to use either a 5.5" (140mm) or 6" (152mm) fl ue. installation and operating instructions. 10) Installer must mechanically attach the sup- plied label to the inside of the fi... -
Page 8: Masonry And Factory Built Fireplace Clearances
(hr)(ft)( R = 1/k x T = 1/0.84 x .75 = 0.893. specifi ed R of 0.893. Since proposed system R is greater than required, the system is Thermal Resistance: acceptable. R = (ft )(hr)( )(K) I1200 Regency Wood Insert... -
Page 9: Installing Your Insert
10) Re-install the door if removed prior to installation. Flue Adaptor Diagram 2 Secure adaptor using 3 screws - 1 in the Pull Rod In Place front and 1 each on the left and right side. Diagram 5 I1200 Regency Wood Insert... -
Page 10: Installation Into Amasonry Fireplace
Regency highly recommends the use of a full liner as the safest installation and provides the most optimum performance. Your retailer should... -
Page 11: Faceplate, Trim & Optional Fan Support Installation
INSTALLATION FACEPLATE, TRIM & OPTIONAL BOTTOM FACEPLATE & FAN SUPPORT INSTALLATION Regular Faceplate Dimensions: Oversize Faceplate Dimensions: I1200 Regency Wood Insert... - Page 12 Diagram 4. Rear View Rear View Diagram 2 If the insert is going to sit on the hearth proceed to "Faceplate Trim Installation" Diagram 4 (step 8) otherwise continue on to "Bottom Faceplate Installation" (step 4). I1200 Regency Wood Insert...
- Page 13 13) To install the optional fan support, measure the distance between the hearth and the bottom surface of the fan housing as shown in Diagram 8. Diagram 6: Shown with Optional Bottom Faceplate Diagram 8: Side View I1200 Regency Wood Insert...
- Page 14 Diagram 6. 22) Re-attach the fan/fan support assembly to the ash lip of the insert. Diagram 9: Rear / Bottom View Completed Faceplate Assembly I1200 Regency Wood Insert...
-
Page 15: Fan / Blower
3) Ensure that the power cord is not in contact with any hot stove surfaces. Neutral Green Manual/ Live Ground Auto 120V AC Switch Switch 60 Hz Fan Thermodisc (normally open) Black Black Black Ground Blower / Fan Wiring Diagram I1200 Regency Wood Insert... -
Page 16: Firebrick Assembly
fi rebox, just below the fl ue baffl e. WARNING: To build a fi re in ignorance or to disregard the informa tion contained in this section can cause serious permanent dam- age to the unit and void your warranty. Front View I1200 Regency Wood Insert... -
Page 17: Screen Door
fi rst few times may damage the paint. Burn fi res at a moderate level the fi rst few days. 8) Do not place anything on the insert top during the curing process. This may result I1200 Regency Wood Insert... -
Page 18: Fan Operation
During constant use, ashes should be removed 9) Your Regency Insert can be very hot. You has been done. In the event that removal is re- every few days. Please take care to prevent the... -
Page 19: Maintenance Of Gold-Plated Doors
REPLACEMENT diameter material must be used. A proper high temperature gasket adhesive is required. A Your Regency Insert is supplied with 5 mm. gasket repair kit, Part # 846-570 is available Neoceram ceramic glass that will withstand the highest heat that your unit will produce. In... -
Page 20: Parts List
36) 033-953 Air Tube - 3/4" (Qty: 1) 38) 073-955 Baffl e (2/set) 47) 846-101 Wood Screen 171-932 Standard Flue Adaptor 171-936 Offset Flue Adaptor 948-216 Regency Logo 918-665 Manual *Not available as a replacement part. I1200 Regency Wood Insert... -
Page 21: Faceplates
Bottom 1 Piece Faceplate 171-572 Trim Set - Oversize Black 65) * Fan Support 171-928 Bottom Piece and Fan Support - Regular *Not available as a replacement part. 171-930 Bottom Piece and Fan Support - Oversize I1200 Regency Wood Insert... -
Page 22: Firebrick
Brick Partial: 1-1/4" x 2" x 9" 81) * Brick Partial: 1-1/4" x 1-1/4" x 9" 84) * Brick Partial: 1-1/4" x 4-1/2" x 8" 85) * Brick Partial: 1-1/4" x 4-1/4" x 8" *Not available as a replacement part. I1200 Regency Wood Insert... -
Page 23: Warranty
The authorized selling dealer is responsible for all in-fi eld service work carried out on your Regency product. FPI will not be liable for results or costs of workmanship from unauthorized service persons or dealers. - Page 24 Dealer Name & Address: ______________________________________________ ___________________________________________________________________ Installer: ___________________________________________________________ Phone #: ___________________________________________________________ Date Installed: ______________________________________________________ Serial No.: __________________________________________________________ Regency is a trademark of FPI Fireplace Products International Ltd. Printed in Canada © Copyright 2011, FPI Fireplace Products International Ltd. All rights reserved.