Operating Instructions; Lighting Procedure; Shutdown Procedure - Regency I43-NG1 Owners & Installation

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS
Before operating this appliance, proceed through the
following check list.
1)
Read and understand these instructions before operating
this appliance.
2) Clean the burner and control compartment of lint and
house dust by brushing and vacuuming regularly. At
least once a year.
3)
Never operate the appliance with any of the glass removed
or with the door open.
4)
Verify log placement. If the pilot cannot be seen when light-
ing the unit - the logs or the embers have been incorrectly
positioned.
5)
The unit should never to turned off and on without a mini-
mum of a 60 second wait.
6)
Do not operate with primary guard removed. See below.
THE GUARD IS FITTED TO THIS APPLIANCE TO REDUCE
THE RISK OF INJURY FROM BURNS AND NO PART OF
IT SHOULD BE PERMANENTLY REMOVED.
FOR PROTECTION OF YOUNG CHILDREN OR THE INFIRM,
A SECONDARY GUARD IS REQUIRED.
16

LIGHTING PROCEDURE

IMPORTANT: Gas cock knob cannot be turned from "PI-
LOT" to "OFF" unless it is partially depressed.
1)
Open the left side door when lighting the pilot, but once
the pilot is lit, DO NOT operate the unit with the front glass
door open.
2)
Open the bottom louvre assembly by turning the wing nut
and swinging the louvres out. (See page 8 for diagram.)
3)
If the control knob is in the "OFF" position proceed to Step
5.
4)
Push in gas control knob slightly and turn clockwise to
"OFF". Knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
5)
Wait fi ve minutes to allow gas, that may have accumulated
in the main burner compartment, to escape. If you do smell
gas, follow the instructions on the front of this manual. If
you don't smell gas continue on to the next step.
6)
Turn the gas control counterclockwise to "PILOT".
7)
Push in control knob all the way and hold in. Immediately
push black button on spark igniter until pilot lights. Continue
to hold the control knob in for approximately one minute,
then release the gas control knob. The pilot fl ame should
continue to burn. If the pilot does not remain lit, repeat
operation allowing a longer period before releasing gas
control knob.
8)
Turn gas control knob counterclockwise to "ON".
9)
Use rocker switch to operate main burner.
10) Rotate the variable fl ame control to adjust the fl ame height
higher or lower.
11) Close the bottom louvre assembly and tighten the wingnut.
12) The door must be closed when operating the unit.

SHUTDOWN PROCEDURE

1)
Use the rocker switch to turn off the main burner.
2)
Open the bottom louvre assembly by turning the wing nut
and swinging the louvres out.
3)
Push in the gas control knob slightly and turn clockwise
to "OFF". Do not force.
4)
Disconnect all electric power to the appliance if service is
to be performed.
Regency I43-1 ULTIMATE Gas Inbuilt Fireplace