Quad Desktop Charger; Nn10042-116 04.01 Standard 4 July; Carrier Voip; Nortel Ip Phone Wlan Handset User Guide (Cicm - Nortel NN10042-116 User Manual

126 Desktop Charger
2
3
4
Procedure Steps
Step Action

Quad Desktop Charger

Procedure Steps
Step
1
2
Copyright © 2008 Nortel Networks
.
The handset can be off or in standby state during charging.
Place the handset, face forward, into the Dual Charger.
The LED displays the charging status. If required, refer to Single
Charger procedure.
Charge the handset battery.
If the handset is in standby mode, it displays its extension
number and Charging. It is fully operational and can receive
calls.
If the handset is off, only Charging is displayed and the handset
cannot receive calls.
It is normal for the battery pack to become warm when charging.
When the handset is fully charged, Charge Complete is
displayed. Remove the handset from the charger.
The battery pack starts to charge.
Action
Insert the battery pack into one of the four charging bays.
The LED above the charging bay turns on.
If the LED starts to blink as soon as the battery pack is inserted,
remove the battery pack and reinsert it into the charger.
If a flashing LED indicates a battery pack failure, check the
battery pack in a different bay or substitute another charger and
repeat the operation that caused the failure.
If the same battery pack lights a steady LED when inserted in a
different bay or charger, the first charger can be faulty. Contact
your system administrator for service information.
When the charge is complete, the LED turns off.
Remove the battery pack from the charger.

Carrier VoIP

Nortel IP Phone WLAN Handset User Guide (CICM)

NN10042-116 04.01 Standard
4 July 2008
--End--
--End--