Configuring The Passport 8250 For Operations; Logging Into The Cli; Starting The Passport 8250 Device And Logging Into The Cli - Nortel Passport 241-5101-200 Installation Manual

Chapter 4
Configuring the Passport 8250 for operations
This section provides the following procedures for configuring the Passport
8250 device for the operations:
1
2
3

Logging into the CLI

The first time you log into the CLI, you need to do the following:
•
•

Starting the Passport 8250 device and logging into the CLI

1
2
"Logging into the CLI" (page 37)
"Configuring the Passport 8250 device for remote access" (page 38)
"Configuring the clocking scheme" (page 40).
Access the CLI using a terminal emulation device that is directly
connected to the Passport 8250 device. The terminal emulation device
must have a standard terminal emulation software.
Create a password. The password is used for CLI sessions, Telnet
sessions, and FTP sessions.
Note: The userid for CLI sessions, Telnet sessions, and FTP sessions is
admin.
Start a hyperterminal session on the local host.
Start the Passport 8250 device:
Passport 8250 Installation Guide R2.2
37