Setup And Operation; Install Remote Controller Battery; Connecting To The Projector - BenQ LU9715 User Manual

Setup and Operation

Install remote controller battery

1. To open the battery cover, turn the remote control over to view its back, push on the finger
grip on the cover and slide it up in the direction of the arrow as illustrated. The cover will slide
off.
2. Remove any existing batteries (if necessary) and install two new AA batteries observing the
battery polarities as indicated in the base of the battery compartment. Positive (+) goes to
positive and negative (-) goes to negative.
3. Refit the cover by aligning it with the case and sliding it back up into position. Stop when it clicks
into place.
1
Precautions relating to batteries
• Do not mix old batteries with new ones, or mix different types of batteries.
• Avoid leaving the remote control and batteries in an excessive hot or humid environment like the kitchen,
bathroom, sauna, sunroom, or a closed car.
• Dispose of used batteries according to the battery manufacturer's instructions and local environment regulations
for your region.
• If the remote control will not be used for an extended period of time, remove the batteries to avoid damage to
the control from possible battery leakage.

Connecting to the projector

If the path between the remote control and the projector is obstructed or remote control
operation is disrupted by certain high-frequency fluorescent lights, you can connect to the
projector with M3 stereo mini jack cable to operate the projector.
20
2
COMPUTER 2
3
COMPUTER 1
3G-SDI