BenQ LU9715 User Manual page 50

HDMI 1.4a 3D input signal
HDMI 1.4a 3D signal sent to the projector through digital transmitter
Side by Side: Set 3D format to Side by Side manually. This option applies to HDMI input signal
or HDMI signal through a digital transmitter.
Top / Bottom: Set 3D format to Top / Bottom. This option applies to HDMI, DVI, or
DisplayPort input signals or these signals through digital transmitter.
Frame Sequential: Set input format to Frame Sequential.
DLP Link: Select to disable or enable DLP Link sync.
3D Swap: Set 3D Swap to reverse if left and right eye 3D image inversion by 3D glasses is
needed. If image looks normal, keeps current settings, Normal, intact.
Caution:
The projector supports DLP Link and 3D IR sync. After 3D mode is enabled, you can sync the
signal of 3D glasses with both built-in DLP Link and external 3D IR transmitter or close the
former and rely on the latter for 3D signal sync. Please remember:
• People with the following conditions should view 3D images with great care:
- Children under six years old
- Those with light sensitization disease, history of heart disease, or poor health
- Those experiencing physical fatigue or a lack of sleep
- Those under the influence of drugs or alcohol
• Under normal conditions it is safe to view 3D images. Some might feel uncomfortable. Please
refer to the guidelines publicized by the 3D alliance on 2008-12-10. Please take at least 5-15
minutes rest for every 30-60 minutes viewing.
• Color Space
This function enables you to change color space of input signal. In most cases, you can select
Auto to adopt the color space automatically set by the projector. You can select one of the
following options to use specific color space instead:
Auto: The projector switches to valid color space by detecting input signal.
YPbPr: Set color space to ITU-R BT.601.
YCbCr: Set color space to ITU-R BT.709.
RGB-PC: Set color space to RGB with black set to 0, 0, 0 and white to 255, 255, 255 (for 8-bit
image).
RGB-Video: Set color space to RGB with black set to 16, 16, 16 and white to 235, 235, 235 (for
8-bit image) to correspond brilliance values with values defined in digital component standard.
• Reset Display
Press "Yes" to reset all setting to default in Display OSD.
50