Ethernet Management Port; Dce/Dte Switch; Serial Ports - Nortel 8003AC Installation Manual

Ethernet routing switch
Table of Contents

Advertisement

Label
Color/State
Fan 1, 2
Green/Steady
Amber/Steady
Temp
Green/Steady
Amber/Steady
Master
Green/Steady
Green/Blinking
Amber/Steady
Off
Online
Green/Steady
Amber/Steady
Off

Ethernet management port

The Ethernet management port on the 8692omSF module is an MDI
10/100BaseT port that allows out-of-band management of the switch using
a Web browser or Device Manager. You can also establish a Telnet or SSH
(Secure Shell) session to access the CLI. Use this port to connect the switch
to a network management station. The Ethernet management port has its
own IP address but does not switch traffic to other ports in the chassis.
Note that you use this port only as a management port. This port provides
out-of-band management for the 8692omSF module.

DCE/DTE switch

The DCE/DTE switch changes the pin assignments on the Console port
and allows you to designate the connector as either DTE or DCE. For
information about pin assignments for the Console port, see
port" (page

Serial ports

The 8692omSF module provides two serial ports for attaching modem
and console devices. The Console port provides terminal access to the
8692omSF module to use the CLI. The Modem port allows you to connect
a standard modem for out-of-band, dial-up management. For information
about pin assignments for these ports, see
132)
Copyright © 2005-2007, Nortel Networks
.
Meaning
The specified fan is operating normally.
The specified fan has failed.
The temperature is normal for switch operation.
The temperature of the switch has exceeded the maximum
operating temperature.
The CPU subsystem on the module is performing diagnostics.
This module is providing active CPU functions for the switch
and is the master CPU module.
The CPU subsystem is in a fault state.
The CPU subsystem on the module is up and is in standby
mode.
The switch fabric portion of the module is online and is
load-sharing.
The switch fabric portion of the module failed diagnostics.
The switch fabric portion of the module is offline.
132).
and
"Modem serial port" (page
Nortel Metro Ethernet Routing Switch 8600
Installation — Modules
NN46220-306 02.02 Standard
4.2 7 July 2008
8692omSF module 71
"Console serial port" (page
133).
"Console serial

Advertisement

Table of Contents
loading

This manual is also suitable for:

8004ac8005ac8005dc8004dc8600

Table of Contents