Prerequisites; Establishing Remote Access - Nortel Secure Router 4134 Quick Start Manual

56 Configuring the Secure Router 4134 for remote access

Prerequisites

•
•
•
•
Procedure steps
Step
1
2
3
4
5

Establishing remote access

The first time you log on to the Secure Router 4134 CLI, you perform initial
configuration such as the following:
1.
2.
3.
4.
Copyright © 2007, 2008 Nortel Networks
.
Ensure you have the supplied console cable.
Ensure you have the supplied female DB-9 to RJ-45 adapter if you
require it for connection to your terminal or PC.
Ensure you have the Secure Router 4134 securely installed in the
equipment rack.
Ensure you have powered up the terminal or PC.
Action
Set the terminal protocol as follows:
a 9600 baud
b 8 data bits
c 1 stop bit
d no parity
e flow control: None
Insert the male RJ-45 connector in the console port on the rear
panel of the Secure Router 4134.
Connect the female DB-9 to RJ-45 adapter to the opposite end
of the console cable, if necessary.
Insert the RJ-45 or female DB-9 connector (dependent on your
equipment) in a terminal or PC.
Power up the Secure Router 4134.
Configure the IP address for the management port.
Configure the next hop (gateway IP address).
Verify a successful connection.
Enable remote access.
You can enable SSH or Telnet for remote connections.
Nortel Secure Router 4134
NN47263-100 02.01 Standard
18 February 2008
--End--
Quick Start