D-Link X-STACK DES-3200 SERIES Reference Manual page 98

®
xStack DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
-
Rule ID : 22
Match on
VLAN ID
Source MAC
Destination MAC :00-05-04-03-02-00
Action:
Deny
DES-3200-28P:admin#
The following example displays the packet content mask profile for the profile with an ID of 4:
DES-3200-28P:admin#show access_profile profile_id 4
Command: show access_profile profile_id 4
Access Profile Table
Profile ID: 4
MASK on
offset_chunk_1 : 3
offset_chunk_2 : 5
offset_chunk_3 : 14
offset_chunk_4 : 16
Available HW Entries : 255
--------------------------------------------------------------------------------
Rule ID : 1
Match on
offset_chunk_1 : 3
offset_chunk_2 : 5
offset_chunk_3 : 14
Action:
Deny
DES-3200-28P:admin#
6-5 config flow_meter
Description
This command is used to configure the flow-based metering function. The metering function
supports three modes: single rate two color, single rate three color, and two rate three color. The
access rule must be created before the parameters of this function can be applied.
For the single rate two color mode, users may set the preferred bandwidth for this rule, in Kbps,
and once the bandwidth has been exceeded, overflowing packets will either be dropped or have a
drop precedence set, depending on the user configuration.
Ports: 1-7
: 8
: 00-01-02-03-04-05
Profile name:4 Type: User Defined
value : 0x0000FFFF
value : 0x0000FF00
value : 0xFFFF0000
value : 0xFF000000
Ports: 1-2
value : 0x000086DD
value : 0x00003A00
value : 0x86000000
Mask : 0xFFF
Mask : FF-FF-FF-FF-FF-FF
Mask : FF-FF-FF-FF-FF-00
94