D-Link X-STACK DES-3200 SERIES Reference Manual page 190

®
xStack DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
18-3 debug output
Description
This command is used to set a specified module's debug message output to debug buffer or local
console. If the user uses the command in a Telnet session, the error message also is output to the
local console.
Format
debug output [module <module_list> | all] [buffer | console]
Parameters
module - Specify the module list.
<module_list> - Enter the module list here.
all - Control output method of all modules.
buffer - Direct the debug message of the module output to debug buffer(default).
console - Direct the debug message of the module output to local console.
Restrictions
Only Administrator-level users can issue this command.
Example
To set all module debug message outputs to local console:
DES-3200-28P:admin#debug output all console
Command: debug output all console
Success.
DES-3200-28P:admin#
18-4 debug config error_reboot
Description
This command is used to set if the Switch needs to be rebooted when a fatal error occurs. When
the error occurs, the watchdog timer will be disabled by the system first, and then all debug
information will be saved in NVRAM. If the error_reboot is enabled, the watchdog shall be enabled
after all information is stored into NVRAM.
Format
debug config error_reboot [enable | disable]
Parameters
enable – If enabled, the Switch will reboot when a fatal error happens.
disable – If disabled the Switch will not reboot when a fatal error happens, system will hang-up
for debug and enter the debug shell mode for debug.
186