Rear End Door Window / Back Window Defogger Wire Repair; Power Window Main Switch Inspection - Suzuki SX4 Service Manual

9E-22 Glass / Windows / Mirrors:
4) Touch voltmeter negative (–) lead to defogger wire
ground terminal end (1).
5) Touch voltmeter positive (+) lead with a foil strip to
defogger wire power source terminal end (2), then
move it along wire to defogger wire ground terminal
end (1).
For hatchback model:
The place where voltmeter fluctuates from 10 – 12 V
to 0 – 1 V is where there is open.
For sedan model:
The place where voltmeter fluctuates from 12 – 14 V
to 5 – 7 V or 5 – 7 V to 0 – 1 V is where there is
open.
If found defective, repair defogger wire referring to
"Rear End Door Window / Back Window Defogger
Wire Repair".
[A]
1
[B]
1
3. Glass antenna [A]: Hatchback
2
3
2
I6RW0B950009-01
[B]: Sedan model
model
Rear End Door Window / Back Window
Defogger Wire Repair
1) Use white gasoline for cleaning.
2) Apply masking tape (1) at both upper and lower
sides of heat wire (2) to be repaired.
3) Apply commercially-available repair agent (3) with a
fine-tip brush (4).
4) 2 to 3 minutes later, remove masking tapes (1).
5) Leave repaired heat wire as it is for at least 24 hours
before operating the defogger again.

Power Window Main Switch Inspection

Switch for driver side window
Without Pinching Prevention Function Model
1) Remove driver side door trim referring to step 1) to
4) of "Front Door Glass Removal and Installation".
2) Remove power window main switch from door trim.
3) Connect 12 V battery positive (+) terminal to terminal
"IG" of power window main switch and its negative (–
) terminal to terminal "E" of power window main
switch.
4) Check for continuity between terminals as shown
below.
If check result is not as specified, replace power
window main switch.
S7RW0A9506020
I2RH01950005-01
S7RW0A9506021