Windshield Wiper Motor Inspection - Suzuki SX4 Service Manual

Installation
1) Install windshield wiper assembly (1), and tighten
bolts to specified torque in order of "i", "ii" and "iii"
indicated in figure.
Tightening torque
Windshield wiper bolt (a): 8 N·m (0.8 kgf-m, 6.0
lb-ft)
ii, (a)
1
2) Connect coupler to windshield wiper motor.
3) Install cowl top garnish referring to "Cowl Top and
Front Lower Crossmember Components in Section
9K".
4) Install windshield wiper arms with wiper blades (1) to
specified position as shown in figure, and then
tighten windshield wiper nuts to specified torque.
Tightening torque
Windshield wiper arm nut (a): 18 N·m (1.8 kgf-
m, 13.0 lb-ft)
5) Install wiper pivot caps (2) to windshield wiper arm
nuts.
[B]
3
6
5
2
1
3. Ceramic line
4. Wiper blade center
5. Wiper blade edge
6) Connect negative (–) cable to battery.
iii, (a)
i, (a)
I5RW0A940006-02
[A]
3
4
2
1
(a)
I7RW01940008-03
6. Ceramic mark
[A]: Driver side
[B]: Passenger side

Windshield Wiper Motor Inspection

NOTE
Make sure that battery voltage is 12 V or
more.
1) Make a mark (1) on windshield wiper motor (2) stop
position as shown.
2
2) Check windshield wiper motor for operation as
follows
• For motor operation in low speed
a. Connect battery positive (+) terminal to
terminal "1" and its negative (–) terminal to
terminal "5".
b. Check if motor revolution speed is as
specification. If check result is not as
specified, replace motor.
Specification
41 – 49 r/min (rpm)
[A]
1
5
[B]
1
5
[A]: LHD
[B]: RHD
Wipers / Washers: 9D-4
S7RW0A9406005
1
I5RW0A940007-01
I5RW0A940008-01