Washer Tank And Washer Pump Removal And Installation; Washer Pump Inspection; Windshield Wiper Removal And Installation - Suzuki SX4 Service Manual

9D-3 Wipers / Washers:
5. Rear wiper arm with blade assembly
6. Rear wiper motor
7. Washer pump for windshield washer
Washer Tank and Washer Pump Removal and
Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove front bumper referring to "Front Bumper
and Rear Bumper Components in Section 9K".
3) Disconnect washer pump lead wire couplers and
hoses.
4) Remove washer tank attaching bolts (4).
5) Remove washer tank (1).
6) Remove windshield washer pump (2) and rear
washer pump (3) from washer tank (1).
1
4
5. Right side headlight housing
Installation
Install washer tank and washer pump by reversing
removal procedure, noting the following instructions.
• Connect washer pump connector(s) and hose
securely.

Washer Pump Inspection

1) Connect battery positive (+) and negative (–)
terminals to pump (+) and (–) terminals respectively.
2) Check windshield and rear washer pumps for
operation.
If pump does not operate, replace washer pump.
12. Wiper switch
13. Rear wiper relay
14. Junction block.
S7RW0A9406002
5
4
3 4 2
I7RW01940007-01
S7RW0A9406003
I5RW0A940004-01

Windshield Wiper Removal and Installation

Removal
1) Disconnect negative (–) cable at battery.
2) Remove wiper pivot caps (1) and wiper arm nuts (2),
and remove windshield wiper arms with wiper blades
(3).
3
3) Remove cowl top garnish referring to "Cowl Top and
Front Lower Crossmember Components in Section
9K".
4) Disconnect coupler from windshield wiper motor.
5) Remove bolts (1), and remove windshield wiper
assembly (2).
1
2
: 8 N⋅m (0.8 kgf-m, 6.0 lb-ft)
: 5 N⋅m (0.5 kgf-m, 4.0 lb-ft)
S7RW0A9406004
1
3
2
I4RS0B940003-03
I5RW0A940005-02