Suzuki SX4 Service Manual page 1210

8B-117 Air Bag System:
Deployment / Activation Inside of Vehicle
When the vehicle will be destroyed, or salvaged for
component parts, deploy the air bag modules and/or
activate seat belt pretensioners installed on vehicle.
NOTE
If equipped with the seat belt pretensioners,
activate both side of seat belt pretensioners
at the same time when using special tool (C).
1) Turn ignition switch to LOCK position, remove key
and put on safety glasses.
2) Remove all loose objects from front seats and
instrument panel.
3) Disconnect air bag (inflator) module or seat belt
pretensioner connector as follows.
• For driver air bag (inflator) module [A]
Remove driver side front pillar lower trim and
disconnect driver air bag (inflator) module
connector (1).
• For passenger air bag (inflator) module [B]
Remove passenger side front pillar lower trim and
disconnect passenger air bag (inflator) module
connector (2).
• For side-air bag (inflator) module [C]
Disconnect side-air bag (inflator) module
connectors (3) under front seat cushion.
• For side curtain-air bag (inflator) module
(hatchback model) [D]
Remove right-side rear quarter lower trim and
disconnect side curtain-air bag (inflator) module
connector (4).
• For side curtain-air bag (inflator) module (sedan
model) [E]
Remove rear piller inner trim and disconnect side
curtain-air bag (inflator) module connector (6).
• For seat belt pretensioners (right and left) [F]
Remove both side (driver and passenger side)
center pillar lower trim and disconnect seat belt
pretensioner connectors (5).
4) Confirm that each air bag (inflator) module and/or
seat belt pretensioners is securely mounted.
[A]
1
[B]
2
[C]
2
1
[D]
4
[E]
2
1
6
[F]
2
1
1
2
3
2
1
5
I7RW0A820007-01