Wiconfig - Pitney Bowes DP50S Operating Instructions Manual

wiconfig

Use the "wiconfig" command to make settings for wireless LAN.
View settings
msh> wiconfig
View wireless LAN settings
msh> wiconfig cardinfo
• If wireless LAN is not working correctly, its information is not displayed.
Configuration
msh> wiconfig "parameter"
Parameter
mode {ap|802.11adhoc}
ssid "ID value"
channel "channel no."
Remote Maintenance by telnet
Value configured
You can set infrastructure mode (ap), or
802.11ad hoc mode (802.11adhoc).
The default is infrastructure mode.
You can make settings for the SSID in theinfra-
structure mode.
Usable characters are ASCII 0x20-0x7e (32
bytes).
An SSID value is set automatically to the
nearestaccess point if no setting is made.
If no setting is made for the ad hoc mode,
thesame value as for the infrastructure mode
or an
ASSID value is automatically set. The default
isblank.
You can enable or disable the WEP function.
Toenable the WEP function, specify [on]; to
disableit, specify [off].
To start the WEP function, enter the correct
WEPkey. The default is "11".
4
167