Configure Date And Time Service - NETGEAR FVS318N Reference Manual

WARNING!
After you have started the firmware installation process, do not
interrupt the process. Do not try to go online, turn off the wireless
VPN firewall, or do anything else to the wireless VPN firewall until
the wireless VPN firewall has fully rebooted.
7. When the reboot process is complete, log in to the wireless VPN firewall again. (If you can
see the unit: The reboot process is complete when the Test LED on the front panel goes off.)
8. Select Monitoring. The Router Status screen displays, showing the new firmware
version in the System Info section of the screen.
Note: In some cases, such as a major upgrade, it might be necessary to
erase the configuration and manually reconfigure your wireless VPN
firewall after upgrading it. See the firmware release notes that
NETGEAR makes available.

Configure Date and Time Service

Configure date, time, and NTP server designations on the System Date & Time screen.
Network Time Protocol (NTP) is a protocol that is used to synchronize computer clock times
in a network of computers. Setting the correct system time and time zone ensures that the
date and time recorded in the wireless VPN firewall logs and reports are accurate.

To set time, date, and NTP servers:
1. Select Administration > Time Zone. The Time Zone screen displays:
Figure 167.
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Network and System Management
288