Create Dmz Wan Rules - NETGEAR FVS318N Reference Manual

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Figure 56.
2. Enter the settings as explained in
3. Click Apply to save your changes. The new rule is now added to the Inbound Services
table.

Create DMZ WAN Rules

The firewall rules for traffic between the DMZ and the Internet are configured on the DMZ
WAN Rules screen. The default outbound policy is to block all traffic from and to the Internet.
You can then apply firewall rules to allow specific types of traffic either going out from the
DMZ to the Internet (outbound) or coming in from the Internet to the DMZ (inbound).
There is no drop-down list that lets you set the default outbound policy as there is on the LAN
WAN Rules screen. You can change the default outbound policy by enabling all outbound
traffic and then blocking only specific services from passing through the wireless VPN
firewall. You do so by adding outbound services rules (see
Rules on page 121).
Table 28 on page 113.
IPv4 Firewall Protection
119
DMZ WAN Outbound Service