Configure Netbios Bridging With Ipsec Vpn - NETGEAR FVS318N Reference Manual

Figure 128.
3. In the IKE SA Parameters section of the screen, locate the DPD fields, and complete the
settings as explained the following table:
Table 55. Dead Peer Detection settings
Setting
IKE SA Parameters
Enable Dead Peer
Detection
4. Click Apply to save your settings.

Configure NetBIOS Bridging with IPSec VPN

Windows networks use the Network Basic Input/Output System (NetBIOS) for several basic
network services such as naming and neighborhood device discovery. Because VPN routers
do not usually pass NetBIOS traffic, these network services do not function for hosts on
opposite ends of a VPN connection. To solve this problem, you can configure the wireless
VPN firewall to bridge NetBIOS traffic over the VPN tunnel.
Virtual Private Networking Using IPv4 IPSec and L2TP Connections
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Description
Select the Yes radio button to enable DPD. When the wireless VPN firewall
detects an IKE connection failure, it deletes the IPSec and IKE SA and forces a
reestablishment of the connection. You need to specify the detection period in
the Detection Period field and the maximum number of times that the wireless
VPN firewall attempts to reconnect in the Reconnect after failure count field.
Detection Period
Reconnect after
failure count
The period in seconds between consecutive
DPD R-U-THERE messages, which are sent only when the
IPSec traffic is idle. The default setting is 10 seconds.
The maximum number of DPD failures before the wireless
VPN firewall tears down the connection and then attempts
to reconnect to the peer. The default setting is 3 failures.
217