Create Lan Dmz Rules - NETGEAR FVS318N Reference Manual

packet matches an inbound rule on the LAN WAN Rules screen, it is not matched against the
inbound rules on the DMZ WAN Rules screen.

To create a new inbound DMZ WAN service rule:
1. In the DMZ WAN Rules screen, click the Add table button under the Inbound Services
table. The Add DMZ WAN Inbound Service screen displays:
Figure 59.
2. Enter the settings as explained in
3. Click Apply to save your changes. The new rule is now added to the Inbound Services
table.

Create LAN DMZ Rules

The LAN DMZ Rules screen allows you to create rules that define the movement of traffic
between the LAN and the DMZ. The default outbound and inbound policies are to block all
traffic between the local LAN and DMZ network. You can then apply firewall rules to allow
specific types of traffic either going out from the LAN to the DMZ (outbound) or coming in
from the DMZ to the LAN (inbound).
There is no drop-down list that lets you set the default outbound policy as there is on the LAN
WAN Rules screen. You can change the default outbound policy by allowing all outbound
traffic and then blocking specific services from passing through the wireless VPN firewall. You
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Table 28
IPv4 Firewall Protection
on page 113.
122