Regular Faceplate Installation - Regency L540PB Owners And Installation Manual

Note: Faceplate may be installed after the unit is in it's fi nal position.
1. Install bracket on left side of unit with 2 screws in locations
shown below.
2. Install bracket with fan speed controller on the right side of the unit.
Connect the 2 wires from the fan speed controller (2 female connectors to
the wires located on the side of the unit (2 male connectors).
Fan Speed Wire Connection
3. Use supplied wire clip to contain excess wire to the back of the bracket.
L540PB-2 / HZI540PB-2 Direct Vent Gas Insert

REGULAR FACEPLATE INSTALLATION

Left Bracket
Wire clip
Wire clip
Wire clip
4. Connect the 2 female wires to the valve at TH/TP-TH terminals.
Valve Wire Connection
5. Cut cable tie to release bundled power cord.
Power Cord
6. Bring power cord to the back of the right bracket (without slack) - secu
with supplied wire clip.
Power Cord wire clip
INSTALLATION
37