Simm Removal - Canon BJ-W3000 Service Manual

3) With the edge of the SIMM in the slot,
roll the SIMM to the left until the hooks
[3] at both ends of the slot click into the
holes at both ends of the SIMM.
[3]
Figure 1-503
4) Attach the cover plate [2] and tighten the
4 screws [1].
REFERENCE
• When only one SIMM is used, it must
be installed in the left slot (SIM601).
• When adding two SIMMs, it is easiest
to install the first one into the left slot
(SIM601).
CHAPTER 1. GENERAL DESCRIPTION
C. SIMM Removal
1) Using the installation tools supplied with
the printer, remove the 4 screws [1] and
the cover plate [2].
[2]
[1]
Figure 1-504
2) Gently pull back the two hooks [3] at
each end of the SIMM. Roll the SIMM to
the right and remove it.
[3]
Figure 1-505
3) Attach the cover plate [2] and tighten the
4 screws [1].
1–37