• Upon completion of data reception, one
of the following messages is displayed.
a: For both the image controller and
engine controller :
I:XX.XX E:XX.XX
[Press Online Ke
[Press Online Key to Write File on Flash]
b: For only the image controller :
I/C XX.XX→XX.XX
[Press Online Ke
[Press Online Key to Write File on Flash]
c: For only the engine controller :
E/C XX.XX→XX XX
[Press Online Ke
[Press Online Key to Write File on Flash]
9) Press the ONLINE key
• Data in the flash memory is erased,
written and verified. During this
process, the following messages are
displayed :
Download Mode
I/C
Download Mode
I/C
Download Mode
I/C
Verifying..
Erasing..
Writing..
CHAPTER 5. TROUBLESHOOTING
Download Mode
E/C
Download Mode
E/C
Download Mode
E/C
Verifying..
Download Mode
[Update Complete]
[Update Completed: Turn Power Off!!]
CAUTION
Do not turn OFF the power switch of the
printer or computer during the download
operation as there is a possibility that the
firmware will not start up.
If the power is accidentally switched off
at the wrong time, turn on the printer
and the computer, and download the
firmware again. If the printer cannot be
started up, replace the PCB that you
tried to download the firmware to.
10) Turn OFF the power switch of the
printer.
11) Turn ON the power switch of the printer.
Check the firmware version and whether
the printer operates normally.
Erasing..
Writing..
5–17