Basic Operation - Canon BJ-W3000 Service Manual

D. Basic Operation
1) Turn the power switch ON.
• The power lamp is lit and the initializa-
tion process beings.
• The initialization completes in about 20
seconds.
2) Make menu settings according to the
computer and application software to be
used.
• Press the online key to cause the menu
selection screen to appear, select a
menu with the right and left arrow
keys, and go to the parameter menu
with the down arrow key. Select
parameters with the right and left
arrow keys. Enter each selection with
the Enter key.
3) Open the front cover.
4) Load paper into the printer.
a. In the case of cut sheets:
[1] Lower the paper release lever.
[2] With the printed surface of the
paper upward, match the paper edge
to the inside of the paper matching
line, and raise the paper release lever.
Paper matching line
PE sensor
Print media
Figure 1-307
CHAPTER 1. GENERAL DESCRIPTION
• When the paper inserted below the
pinch roller unit is detected by the PE
sensor, the suction fan runs and the
paper is sucked to the platen.
• If the printer does not start within about
1 minute after the suction fan operates,
the fan stops.
b. In the case of roll media:
[1] Lower the paper release lever.
[2] Keeping the roll media tight (no
slack), pull it out straight onto the
platen from the back side of the
printer.
[3] Raise the paper release lever so that
the roll media is fed in parallel with
the paper matching line.
Paper
matching line
PE sensor
Print media
Figure 1-308
Paper
matching line
1–29