Feeder Unit; Removing The Pinch Roller Unit - Canon BJ-W3000 Service Manual

CHAPTER 3. MECHANICAL SYSTEM
IV. FEEDER UNIT

1. Removing the pinch roller unit

1) Remove the lower cover
2) Raise the paper release lever [1], remove
the E ring [2] and remove the paper
release lever.
Figure 3-401
3) Remove screws [5] (A0 size model: 14,
A1 size model: 8), and remove the pinch
roller unit [6].
[5]
[6]
Figure 3-402
3–24
(See page 3-8).
[1]
[2]
[5]
CAUTION
• When installing the pinch roller shaft,
be careful about the position.
• Install the pinch roller unit with the
screws [A] of the pinch roller facing
upward (See Figure
• When installing the pinch roller unit,
tighten the screws in order from the
left one at the back of the main unit
(See Figure 3-404).
3-403).